FREETECHEXAMS.COM
HOME  |    CONTACT US  |   ADD TO FAVOURITES
 
Home » Cisco » CCENT » CCENT Practice Exam Questions Tests

CCENT Practice Exam Questions (Test):

Free Tech Exams dot com provides free Cisco CCENT Certification Practice tests to help you prepare for final exam. Please read a word about CCENT Braindumps Certification.

Start your CCENT practice test
 

25 CCENT Practice Test Questions
01. Why would a network administrator configure port security on a switch?

02. Which form of NAT maps multiple private IP addresses to a single registered IP address by using different ports?

03. What should be part of a comprehensive network security plan?

04. Which of the following commands will configure a default route to any destination network not found in the routing table?

05. For security reasons, information about RTA, including platform and IP addresses, should not be accessible from the Internet. This information should, however, be accessible to devices on the internal networks of RT A. Which command or series of commands will accomplish these objectives?

06. What is the purpose of flow control?

07. Host A has established a communication session with host B for the first time. What enabled R1 to forward this traffic in the appropriate direction to reach the nework to which host B is attached?

08. What does the "Inside Global" address represent in the configuration of NAT?

09. How many simultaneous Telnet sessions does a Cisco router support by default?

10. which prompt is the global configuration mode on a Cisco router identified?

11. Host A is communicating with the server. What will be the source MAC address of the frames received by Host A from the server?

12. Which IP address is a private address?

13. Which encryption type does WPA2 use?

14. Which of the following protocols uses both TCP and UDP ports?

15. Three access points have been installed and configured to cover a small office. What term defines the wireless topology?

16. Which command is used on a Cisco router to reach the global configuration mode?

17. Which command will set the default gateway to 192.168.12.1 on a Cisco switch?

18. What is the effect of using the service password-encryption command?

19. What is the purpose of a default route?

20. Workstation A must be able to telnet to switch SW-A through router RTA for management purposes. What must be configured for this connection to be successful?
21. At which layer of the OSI model does the protocol that provides the information displayed by the show cdp neighbors command operate?
22. Serial0/0 does not respond to a ping request from a host on the FastEthernet0/0 LAN. How can this problem be corrected?
23. Which form of NAT maps multiple private IP addresses to a single registered IP address by using different ports?
24. Why would a network administrator configure port security on a switch?
25. Which form of NAT maps multiple private IP addresses to a single registered IP address by using different ports?



HOME CONTACT US ADD TO FAVOURITES
© COPYRIGHT 2005 - 2007 FREETECHEXAMS.COM ALL RIGHTS RESERVED.