Free Tech Exams
HOME
COMPTIA
A+ Practice Tests
Network+ Practice Tests
Security+ Practice Tests
CISCO
CCT Practice Tests
CCNA Practice Tests
CCNP Practice Tests
MICROSOFT
MTA Practice Tests
✕
MTA Practice Test 4
Home
MTA Practice Test 4
Start your MTA Practice Test 4
Which routing protocols consider hop count to determine the next hop? (Choose two.)
A.Lisp
B. OSPF
C.BGP
D. EIGRP
What is one reason for creating an IPv4 over IPv4 tunnel?
A. To enable IPv6
B. To extend a subnet
C. To send unicast traffic over a VXLAN
D. To send multicast traffic over a unicast-only underlay
Which of the following does BGP advertise?
A. Cost
B. The best path to a prefix
C. All paths to a prefix
D. Weight
What happens if you use issue the EIGRP router configuration command network 10.9.9.0?
A. EIGRP will advertise 10.0.0.0/8.
B. EIGRP won’t advertise anything.
C. EIGRP won’t form an adjacency over any interfaces with addresses in the 10.0.0.0/8 range.
D. EIGRP will advertise 10.9.9.0/24.
Which OSPF route is most preferred?
A. Inter-area
B. Intra-area
C. External
D. Internal
Which OSPF network type is appropriate for loopback interfaces?
A. Null
B. Multiaccess
C. Broadcast
D. Point-to- point
If no loopback interfaces are configured, and if no router ID is configured, where will an OSPF router get its router ID?
A. Highest numbered IPv4 address on a physical interface
B. Lowest numbered IPv4 address on a physical interface
C. It will randomly generate one.
D. It will use the RID 0.0.0.0.
Which of the following does the Cisco Express Forwarding (CEF) adjacency table contain?
A. Next-hop address
B. IP prefix
C. Incoming interface
D. A precomputed layer 2 header
Which administrative distance is considered unreachable?
A. 0
B. 254
C. 255
D. 256
What causes Open Shortest Path First (OSPF) routers to remain in a two-way state with each other?
A. Duplicate router ID (RID)
B. Point-to-point network type
C. Absence of a designated router (DR)
D. Neither is a designated router (DR) or backup DR.
Time's up