CCT Practice Test 2

You are connecting your laptop to the network to perform some connectivity tests. What type of cable should you use to connect your laptop to a port on the switch?

What command would you use on your router to configure the internal Gigabit Ethernet port to receive an IP address automatically?

You have changed the IP address of the Gigabit Ethernet interface on your router. Where is the configuration change stored on the device?

You have telnetted into your switch from your router. What command would you use to suspend the telnet session?

You need to change your laptop to use a static IP address. Which of the following best represents the steps required to do this?

Your manager is concerned about the security risks involved with using telnet as a remote administration protocol to your company routers and switches. Which of the following would you present as a solution ?

Which bits in the configuration register correspond to the boot field bits?

You have subscribed to a T1 connection with your service provider to get access to the WAN environment. What component is needed to connect your router to the T1 link?

Which of the following IPv6 address is a link-local address?

What command would you use to initiate the System Configuration Dialog?